Bob Smith Industries

INSTA-SET CA Accelerator Pump Spray 2oz 151

INSTA-CURE Super Thin CA 1oz 102 | Shop BSI, Pacer, & Tamiya adhesives for modeling at Texas's coolest hobby shop!

Pocket CA Extender Tip for Pocket CA Tops (6)Pocket CA Extender Tip for Pocket CA Tops (6) For use with BSI's Pocket CAs. It slips over the tip of the Pocket CA top to allow for finer...

QUIK-CURE 5 Minute Epoxy 4.5oz 201ABOUT QUIK-CURE™ 5 min. epoxy cures to a slightly flexible consistency. This lack of brittleness allows it to form a lasting bond in areas subjected to high...

ABOUT Insta-Cure™ has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held...

ABOUT Pocket CAs are available in 3/4 & 4 oz. sizes and feature a top that has a pin built into the cap that covers the nozzle. This pin seals the bottle so that if it is tipped over, the bottle...

ABOUT Plastic-Cure™ is a gap-filling formulation of CA that works best on plastics. It is packaged in a bottle with a brush built into its top, which in many cases is an easier way to apply the CA...

ABOUT Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly...

ABOUT Maxi-Cure™ extra thick CA is the best CA for most plastics, including GE’s Lexan MAXI-CURE™ is the best choice for plastic model assembly. When used with INSTA-SET™, it works better than any...

ABOUT Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly...